HAD Heavy Abrasive Duty Slurry Pump(Repalce AH)

Short Description:

HAD Slurry Pump (For Heavy Abrasive Slurry-Repalce AH)

Model: HAD

Head: 9-95m

Capacity: 3-5000m3/h

Pump type: Horizontal

Media: Slurry

Material: Cr27,Cr28,CD4MCu,rubber liner material

HAD Series Slurry Pump Design features

Description

HAD hard metal/rubber heavy duty slurry pumps are designed for the most difficult pumping applications for high abrasive, high density or erosive slurry. Extra thick sections at wear point and perfect impeller structure ensures satisfactory performance with long life, and needs minimum maintenance requirements.Rubber lined pump expand applications to chemical products handing, several different rubber options are available to meet different application needs. Especially fit in aggressive applications like mill discharge, tailing transportation.

Shaft sleeve

A large percentage of duties allow the use of the centrifugal seal which eliminates the need of sealing water.
Gland shaft seal

A packed gland type shaft seal is also available and can be fitted with a low flow or a full flow flush seal water arrangement.
Shaft and bearing assembly

A large diameter shaft with a short overhang minimizes deflection and vibration.Heavy-duty roller bearings are housed in a removable bearing cartridge.
Pump Base

Aliquam lorem ante, dapibus in, viverra quis, feugiat a, tellus. Phasellus viverra nulla ut metus varius laoreet. Quisque rutrum. Aenean imperdiet. Etiam ultricies nisi vel augue. Curabitur ullamcorper ultricies nisi. Nam eget dui. Etiam rhoncus. Maecenas tempus, tellus eget condimentum rhoncus, sem quam semper libero, sit amet adipiscing sem neque sed ipsum. Nam quam nunc, blandit vel, luctus pulvinar, hendrerit id, lorem. Maecenas nec odio.
SWITCH Interchangeability system

A minimum number if through bolts hold the pump casing to the frame .A means of impeller adjustment is provided in a convenient position below the bearing housing.
Outer Casing

Split outer casing halves of cast or ductile iron contain the wear liners and provide high operation pressure capabilities.
Impeller

The impeller may be either moulded elastomer or hard metal.Deep side sealing vanes relieve seal pressure and minimize recirculation.

Cast-in impeller threads are better suited for slurries.

Interchangeable hard metal and moulded elastomer liners.

Mating faces in hard metal liners are tapered to allow positive alignment during assembly and allow components to be easily removed for replacement.

Hydraulic seal rings give positive sealing between mating faces.